Opel Corsa Owners Manual: Fog lights, Front turn signal lights, Tail lights

Fog lights

Have bulbs replaced by a workshop.

Front turn signal lights

Front turn signal lights
Front turn signal lights

1. Rotate bulb holder anti-clockwise to disengage.

2. Push bulb into socket slightly,


2. Push bulb into socket slightly, rotate anti-clockwise, remove and renew bulb.

3. Insert bulb holder in reflector, rotate clockwise to engage.

Tail lights

5-door Hatchback
5-door Hatchback

1. Open side cover.

2. Remove plug connector by


2. Remove plug connector by pressing on bulb holder tab.

3. Hold bulb housing from the outside; unscrew two retaining nuts.

4. Detach bulb housing towards the


4. Detach bulb housing towards the rear.

5. Gently press the three locking


5. Gently press the three locking lugs on the outside of the bulb holder outwards and remove bulb holder.

6. Push bulb into socket slightly,


6. Push bulb into socket slightly, rotate anti-clockwise, remove and renew bulb.

Tail light (1)
Reverse light (2)
Turn signal light (3)
Tail light/brake light (4) Rear fog light, may be only on one side (5)
7. Engage bulb holder in bulb housing, ensuring that it properly engages.

8. Ensure that the bulb holder seal is


8. Ensure that the bulb holder seal is positioned as illustrated.

9. Insert bulb housing in vehicle


9. Insert bulb housing in vehicle body, tighten securing nuts by hand. Engage plug connector.

Close cover.

After bulb replacement, check the tail lights for proper functionality: switch on the ignition, operate the brake, switch on the side lights.

3-door Hatchback, van
3-door Hatchback, van

1. Open side cover.

2. Remove plug connector by


2. Remove plug connector by pressing on bulb holder tab.

3. Hold bulb housing from the outside; unscrew two retaining nuts.

4. Remove tail light assembly.


4. Remove tail light assembly.

5. Gently press the three locking


5. Gently press the three locking lugs on the outside of the bulb holder outwards and remove bulb holder.

6. Push bulb into socket slightly,


6. Push bulb into socket slightly, rotate anti-clockwise, remove and renew bulb.

Reverse light (right side), rear fog light (left side) (1)
Tail light (2)
Turn signal light (3)
Tail light/brake light (4) Tail light (5)
7. Engage bulb holder in bulb housing, ensuring that it properly engages.

8. Ensure that the bulb holder seal is


8. Ensure that the bulb holder seal is positioned as illustrated. Fit the round seal on the fastening bolt.

9. Insert bulb housing in vehicle body, and tighten securing nuts by hand. Engage plug connector.

Close and lock cover.

After bulb replacement, check the tail lights for proper functionality: switch on the ignition, operate the brake, switch on the side lights.

    Adaptive forward lighting
    Adaptive forward lighting Headlights have separate systems for low beam 1 (outer bulbs) and high beam 2 (inner bulbs). The cornering light is also located behind the cover for the high beam. D ...

    Side turn signal lights, Number plate light., Interior lights
    Side turn signal lights Have bulbs replaced by a workshop. Number plate light. Number plate light 1. Insert screwdriver in bulb housing, press to the side and rele ...

    See also:

    Opel Corsa Owners Manual. Headlights when driving abroad
    The asymmetrical headlight beam extends visibility at the edge of the road at the passenger side. However, when driving in countries where traffic drives on the opposite side of the road, adjust ...


    0.0187