Opel Corsa B 1993–2000 Service and Repair Manual: Pistons and connecting rods - removal and refitting

The piston crowns are not marked to show their direction of fitting, but the underside of the piston is (see illustration).

OHC engines
Large land (arrowed) faces the flywheel end of the engine

Flywheel - removal and refitting

On 1.6 (16SV and C16NZ), 1.8 (18SE) and all 2.0 litre engines note that it will be necessary to remove the transmission or engine in order to remove the flywheel. On all engines, on refitting, use thread locking compound on the flywheel bolts and tighten them to the specified torque.

    Oil pump - removal and refitting
    Removal 1. Remove the camshaft toothed belt and the sump. 2. Slacken and remove the crankshaft sprocket centre bolt and remove the sprocket and spacers, noting their correct fitted locations. Extr ...

    Crankshaft front oil seal - removal and refitting
    Removal 1. Remove the camshaft toothed belt. On 1.6 (16SH), 1.8 and 2.0 litre models, note that it will also be necessary to undo the crankshaft sprocket centre bolt and remove the sprocket and ...

    See also:

    Opel Corsa B 1993–2000 Service and Repair Manual. Wind deflector - removal and refitting
    Removal 1. The wind deflector fills the gap between the rear of the bonnet and the base of the windscreen. 2. Remove both windscreen wiper arms. 3. Remove the wind deflector securing screws (see ...


    0.0062