Opel Corsa B 1993–2000 Service and Repair Manual: Engine components - examination and renovation
Camshaft
1. With the camshaft removed, examine the bearings for signs of obvious wear and pitting.
If evident, a new camshaft housing will probably be required.
2. The camshaft itself should show no marks or scoring on the journal or cam lobe surfaces. If evident, renew the camshaft.
When renewing a camshaft, it should be noted that, in some instances, a camshaft with undersize bearing journals and appropriately-machined carrier journals may have been fitted by the manufacturer. Where applicable, such camshafts are colour-coded violet for identification, and this should be checked to ensure that the correct replacement is obtained.
3. The retaining plate should appear unworn and without grooves. In any event, check the camshaft endfloat and fit a new plate where necessary.
4. The housing front oil seal should always be renewed at major overhaul.
Camshaft toothed belt
5. Closely inspect the belt for cracking, fraying or tooth deformation. Where evident, renew the belt.
6. If the belt has been in use for 30 000 miles or more, it is recommended that it is renewed even if it appears in good condition.
7. Whenever the original belt is to be removed, but is going to be used again, always note its running direction before removing it. It is even worthwhile marking the tooth engagement points on each sprocket.
As the belt will have worn in a set position, refitting it in exactly the same way will prevent any increase in noise which might otherwise occur when the engine is running.
Valve lifters, rockers and thrust pads
8. Any signs of wear in a hydraulic lifter can only be rectified by renewal, the unit cannot be dismantled.
9. Inspect the rockers and thrust pads for wear or grooving. Again, renew if evident.
Piston/bore grade marks
10. The number or code denoting the piston and bore grade (see Specifications) will be found on the sump sealing surface of the smaller engines, and near the engine number on the larger engines.
Crankshaft and main bearings - removal and refitting
Removal 1. With the engine removed from the car, and all the components removed from it, as described in earlier Sections, the crankshaft can be removed as follows. 2. Invert the engine so that it ...Engine lubrication and crankcase ventilation systems - general description
1. Oil pressure for all moving components is provided by a gear type oil pump which is driven from the front end of the crankshaft. The crankshaft has flats for this purpose. 2. The pump draws o ...See also:
Opel Corsa B 1993–2000 Service and Repair Manual. Electrical system
Note: For problems associated with the starting system, refer to the
faults listed under "Engine" earlier in this Section.
Battery will not hold a charge for more than a few days
Battery defecti ...