Opel Corsa B 1993–2000 Service and Repair Manual: Choke cable - removal, refitting and adjustment
Removal
1. Disconnect the battery earth lead.
2. Tap out the small pin which secures the choke control knob to the cable end fitting.
Unscrew and remove the knob.
3. Undo the retaining ring or nut which secures the choke control to the facia. Push the control into the facia and disconnect the warning light switch (when fitted).
4. Remove the air cleaner.
5. Disconnect the choke inner and outer cable from the carburettor (see illustration). On some carburettors the inner cable is secured by a grub screw which must be undone with an Allen key.
Choke cable inner clamp screw
(arrowed)
6. Release the bulkhead grommet and remove the cable.
Refitting
7. Refit in the reverse order to removal, adjusting the cable as follows.
Adjustment
8. Adjust the positions of the inner and outer cables at the carburettor so that, with the control knob pushed home, there is a small amount of slack in the inner cable. Secure the cable in position then operate the choke control knob and check that the choke linkage opens fully.
Accelerator cable - removal, refitting and adjustment
Removal 1. Remove the air cleaner. 2. Extract the spring clip (when fitted) and disconnect the cable ball end from the carburettor throttle lever (see illustration). Accelerator cable ball and ...Carburettor - description
1. Several types and makes of carburettor are fitted to the vehicles covered by this manual. All are of the downdraught type. 2. The 32 TL carburettor fitted to the 1.2 engine is a fixed jet, si ...See also:
Opel Corsa B 1993–2000 Service and Repair Manual. Rear axle assembly - removal
and refitting
Removal
1. Slacken the rear wheel bolts, raise and
support the rear of the vehicle and remove the rear
wheels.
2. On vehicles with a level control system,
depressurise it at the filling valve.
3 ...